Wattage Selectable High Power IK10 impact resistant IP65 LED Highbay with superior efficiency of up to 185lm/W. Tool free interchangeable Lense design. Comes with 110° lense as standard, 90° lense options available as accessory. Integrated 0-10V dimmable LED driver pre-wired with 1500mm cable/220mm dim wire for ease of installation. 800mm safety cable included. Zhaga base for plug and play Microwave or PIR Sensor Module with detection range up to 12m. Sensor options available as accessory. Suitable for -40° - +50° ambient working temperature.
Non-dimmable Constant Voltage (CV) LED driver. SELV type with Short circuit, Overload and Over voltage protection. Loop in/out on primary side, 3 X 24 VDC outputs on screw terminal block. IP20 for indoor use. Independent cable clamps ( inlet / outlet ).
Non-dimmable Constant Voltage (CV) LED driver. SELV type with Short circuit, Overload and Over voltage protection. 2 x 24 VDC outputs on screw terminal block. IP20 for indoor use. Independent cable clamps ( inlet / outlet ).
Non-dimmable Constant Voltage (CV) LED driver. SELV type with Short circuit, Overload and Over voltage protection. 2 x 24 VDC outputs on screw terminal block. IP20 for indoor use. Independent cable clamps ( inlet / outlet ).
Non-dimmable Constant Voltage (CV) LED driver. SELV type with Short circuit, Overload and Over voltage protection. 2 x 24 VDC outputs on screw terminal block. IP20 for indoor use. Independent cable clamps ( inlet / outlet ).
Dimmable Phase Cut ( TRIAC) Constant Voltage (CV) LED driver. SELV type with Short circuit, Overload and Over voltage protection. 2 x 24 VDC outputs on screw terminal block. IP20 for indoor use. Independent cable clamps ( inlet / outlet ).
Dimmable Phase Cut ( TRIAC) Constant Voltage (CV) LED driver. SELV type with Short circuit, Overload and Over voltage protection. 2 x 24 VDC outputs on screw terminal block. IP20 for indoor use. Independent cable clamps ( inlet / outlet ).
High intensity SMD LED Strip with 3m self adhesive tape. Cut points every 50mm for maximum flexibility. Beam angle of 120° and 120 LEDs per metre. For runs over 10 metres individual lengths should be connected in parallel.
High intensity SMD LED Strip with 3m self adhesive tape. Cut points every 50mm for maximum flexibility. Beam angle of 120° and 120 LEDs per metre. For runs over 10 metres individual lengths should be connected in parallel.
High intensity SMD LED Strip with 3m self adhesive tape. Cut points every 50mm for maximum flexibility. Beam angle of 120° and 120 LEDs per metre. For runs over 10 metres individual lengths should be connected in parallel.
Deutsch
Français
