Wattage Switchable Low Glare Surface Mount Commercial Linear as perfect energy saving solution to fluorescent fittings. Robust quality housing with micro-prismatic optics ensures even and uniform light distribution with minimal glare UGR19. Drop down gear tray can be locked after installation and maintenance for safer operation. Non dimmable driver with push-fit terminal enables rapid installation. Wattage Switchable during installation between 34W/43W/52W and 60W.
Wattage Selectable High Power IK10 impact resistant IP65 LED Highbay with superior efficiency of up to 185lm/W. Tool free interchangeable Lense design. Comes with 110° lense as standard, 90° lense options available as accessory. Integrated 0-10V dimmable LED driver pre-wired with 1500mm cable/220mm dim wire for ease of installation. 800mm safety cable included. Zhaga base for plug and play Microwave or PIR Sensor Module with detection range up to 12m. Sensor options available as accessory. Suitable for -40° - +50° ambient working temperature.
Non-dimmable Constant Voltage (CV) LED driver. SELV type with Short circuit; Overload and Over voltage protection. Loop in/out on primary side; 3 X 24 VDC outputs on screw terminal block. IP20 for indoor use. Independent cable clamps ( inlet / outlet ).
Non-dimmable Constant Voltage (CV) LED driver. SELV type with Short circuit; Overload and Over voltage protection. 2 x 24 VDC outputs on screw terminal block. IP20 for indoor use. Independent cable clamps ( inlet / outlet ).
Single colour high intensity COB LED Strip with 3m self adhesive backing for continuous light without LED hotspots. Cut points every 50mm for maximum flexibility. Beam angle of 150° and 480 LEDs per metre. For runs over 5 metres individual lenghts should be connected in parallel.
Single colour high intensity COB LED Strip with 3m self adhesive backing for continuous light without LED hotspots. Cut points every 50mm for maximum flexibility. Beam angle of 150° and 480 LEDs per metre. For runs over 5 metres individual lenghts should be connected in parallel.
Single colour high intensity COB LED Strip with 3m self adhesive backing for continuous light without LED hotspots. Cut points every 50mm for maximum flexibility. Beam angle of 150° and 480 LEDs per metre. For runs over 5 metres individual lenghts should be connected in parallel.
Single colour high intensity COB LED Strip with 3m self adhesive backing for continuous light without LED hotspots. Cut points every 50mm for maximum flexibility. Beam angle of 150° and 480 LEDs per metre. For runs over 5 metres individual lenghts should be connected in parallel.
This website uses cookies to ensure you get the best experience on our website
Deutsch
Français
