Deutsch
Français
RANGES
There are 62 products.
Active filters
LEDline - ST156213
High intensity SMD LED Strip with 3m self adhesive tape.
Cut points every 50mm for maximum flexibility.
Beam angle of 120° and 120 LEDs per metre.
For runs over 10 metres individual lengths should be connected in parallel.
Cut points every 50mm for maximum flexibility.
Beam angle of 120° and 120 LEDs per metre.
For runs over 10 metres individual lengths should be connected in parallel.
LEDline - ST156220
High intensity SMD LED Strip with 3m self adhesive tape.
Cut points every 50mm for maximum flexibility.
Beam angle of 120° and 120 LEDs per metre.
For runs over 10 metres individual lengths should be connected in parallel.
Cut points every 50mm for maximum flexibility.
Beam angle of 120° and 120 LEDs per metre.
For runs over 10 metres individual lengths should be connected in parallel.
LEDline - ST156367
High intensity SMD LED Strip with 3m self adhesive tape.
Cut points every 100mm for maximum flexibility.
Beam angle of 120° and 120 LEDs per metre.
For runs over 5 metres individual lengths should be connected in parallel.
Cut points every 100mm for maximum flexibility.
Beam angle of 120° and 120 LEDs per metre.
For runs over 5 metres individual lengths should be connected in parallel.
LEDline - ST156435
High intensity SMD LED Strip with 3m self adhesive tape.
Cut points every 100mm for maximum flexibility.
Beam angle of 120° and 120 LEDs per metre.
For runs over 10 metres individual lengths should be connected in parallel.
Cut points every 100mm for maximum flexibility.
Beam angle of 120° and 120 LEDs per metre.
For runs over 10 metres individual lengths should be connected in parallel.
LEDline - ST159665
High intensity SMD LED Strip with 3m self adhesive tape.
Cut points every 50mm for maximum flexibility.
Beam angle of 120° and 120 LEDs per metre.
For runs over 10 metres individual lengths should be connected in parallel.
Cut points every 50mm for maximum flexibility.
Beam angle of 120° and 120 LEDs per metre.
For runs over 10 metres individual lengths should be connected in parallel.
made by concatenation
Dimmable Phase Cut ( TRIAC) Constant Voltage (CV) LED driver.
SELV type with Short circuit; Overload and Over voltage protection.
2 x 24 VDC outputs on screw terminal block.
IP20 for indoor use.
Independent cable clamps ( inlet / outlet ).
SELV type with Short circuit; Overload and Over voltage protection.
2 x 24 VDC outputs on screw terminal block.
IP20 for indoor use.
Independent cable clamps ( inlet / outlet ).
made by concatenation
Non-dimmable Constant Voltage (CV) LED driver.
SELV type with Short circuit; Overload and Over voltage protection.
2 x 24 VDC outputs on screw terminal block.
IP20 for indoor use.
Independent cable clamps ( inlet / outlet ).
SELV type with Short circuit; Overload and Over voltage protection.
2 x 24 VDC outputs on screw terminal block.
IP20 for indoor use.
Independent cable clamps ( inlet / outlet ).
made by concatenation
Non-dimmable Constant Voltage (CV) LED driver.
SELV type with Short circuit; Overload and Over voltage protection.
2 x 24 VDC outputs on screw terminal block.
IP20 for indoor use.
Independent cable clamps ( inlet / outlet ).
SELV type with Short circuit; Overload and Over voltage protection.
2 x 24 VDC outputs on screw terminal block.
IP20 for indoor use.
Independent cable clamps ( inlet / outlet ).
made by concatenation
Non-dimmable Constant Voltage (CV) LED driver.
SELV type with Short circuit; Overload and Over voltage protection.
2 x 24 VDC outputs on screw terminal block.
IP20 for indoor use.
Independent cable clamps ( inlet / outlet ).
SELV type with Short circuit; Overload and Over voltage protection.
2 x 24 VDC outputs on screw terminal block.
IP20 for indoor use.
Independent cable clamps ( inlet / outlet ).
made by concatenation
Non-dimmable Constant Voltage (CV) LED driver.
SELV type with Short circuit; Overload and Over voltage protection.
Loop in/out on primary side; 3 X 24 VDC outputs on screw terminal block.
IP20 for indoor use.
Independent cable clamps ( inlet / outlet ).
SELV type with Short circuit; Overload and Over voltage protection.
Loop in/out on primary side; 3 X 24 VDC outputs on screw terminal block.
IP20 for indoor use.
Independent cable clamps ( inlet / outlet ).
made by concatenation
Colour & Wattage Switchable IP65 Die-Cast Aluminium Bulkhead with opal polycarbonate IK10 diffuser for even and uniform light distribution.
4 Wattage and 3 Colour Selections available for ultimate flexibility in every application.
IP65 rated side and rear entry access wiring compartment enable quick and simple through-wiring and product installation.
IK10 polycarbonate diffuser and Die Cast aluminium housing vandal-proof.
Microwave Sensor version with adjustable daylight harvesting. Function (25lux/off), 108° detection range up to 4 meter and hold time configurations from 5 seconds to 10 minutes available.
4 Wattage and 3 Colour Selections available for ultimate flexibility in every application.
IP65 rated side and rear entry access wiring compartment enable quick and simple through-wiring and product installation.
IK10 polycarbonate diffuser and Die Cast aluminium housing vandal-proof.
Microwave Sensor version with adjustable daylight harvesting. Function (25lux/off), 108° detection range up to 4 meter and hold time configurations from 5 seconds to 10 minutes available.
made by concatenation
Colour & Wattage Switchable IP65 Die-Cast Aluminium Bulkhead with opal polycarbonate IK10 diffuser for even and uniform light distribution.
4 Wattage and 3 Colour Selections available for ultimate flexibility in every application.
IP65 rated side and rear entry access wiring compartment enable quick and simple through-wiring and product installation.
IK10 polycarbonate diffuser and Die Cast aluminium housing vandal-proof.
4 Wattage and 3 Colour Selections available for ultimate flexibility in every application.
IP65 rated side and rear entry access wiring compartment enable quick and simple through-wiring and product installation.
IK10 polycarbonate diffuser and Die Cast aluminium housing vandal-proof.
made by concatenation
Corrosion-resistant eco linear batten IP66 rated with opal diffuser for even and uniform light distribution offers best value for money.
IP66 rated cable glands on both ends with 3pol terminal block enable quick and simple through-wiring and product installation.
IK08 polycarbonate diffuser and housing vandal-proof.
Résisant aux UV et conçu pour les environnements extérieurs non abrités avec températures ambiantes de -20°C à +45°C.
IP66 rated cable glands on both ends with 3pol terminal block enable quick and simple through-wiring and product installation.
IK08 polycarbonate diffuser and housing vandal-proof.
Résisant aux UV et conçu pour les environnements extérieurs non abrités avec températures ambiantes de -20°C à +45°C.
made by concatenation
Corrosion-resistant eco linear batten IP66 rated with opal diffuser for even and uniform light distribution offers best value for money.
IP66 rated cable glands on both ends with 3pol terminal block enable quick and simple through-wiring and product installation.
IK08 polycarbonate diffuser and housing vandal-proof.
UV resistant and suitable for installations in unprotected outdoor areas with ambient temperatures from –20 °C to +45 °C.
IP66 rated cable glands on both ends with 3pol terminal block enable quick and simple through-wiring and product installation.
IK08 polycarbonate diffuser and housing vandal-proof.
UV resistant and suitable for installations in unprotected outdoor areas with ambient temperatures from –20 °C to +45 °C.
SpryteCS - DL149963
Colour Switchable compact integrated IP44 Triac dimmable Polycarbonate LED Downlights for installations in shallow ceiling voids.
Fixed and Adjustable versions offer best value for money and are ideal as GU10 replacement installations in limited recess space (56mm height).
LEDchroic lens design with 60° beam angle imitates the appearance of halogen lamps and provides controlled, uniform light distribution with minimal glare.
Class II and air leakage tested meeting latest building regulation requirements.
Pre-wired with 500mm 2 core cable allows tool free rapid installation.
Fixed and Adjustable versions offer best value for money and are ideal as GU10 replacement installations in limited recess space (56mm height).
LEDchroic lens design with 60° beam angle imitates the appearance of halogen lamps and provides controlled, uniform light distribution with minimal glare.
Class II and air leakage tested meeting latest building regulation requirements.
Pre-wired with 500mm 2 core cable allows tool free rapid installation.